Select and inspect a ladder

What you should be able to do

Choose access equipment for the work, then inspect the actual equipment. A ladder that reaches the location can still be unsuitable or defective.

Think About The Assignment

Before selecting equipment, describe where the work occurs, what the worker must handle and the space available. Discuss height, intended load and site conditions with the responsible supervisor, using the ladder's instructions and markings. If a ladder cannot accommodate the work safely, ask for a different access plan.

The Illustrated Checks

The open stepladder illustrates one access type, not an automatic recommendation for every overhead cable job. The cracked rail, missing foot pad and bent step are inspection findings. Record the specific component and condition. Do not let a clean appearance elsewhere cancel out a defect.

Osha Construction Context

OSHA 1926.1053 requires ladders to be inspected by a competent person for visible defects periodically and after any occurrence that could affect their safe use. Workers must still check the actual ladder and report observed defects before relying on it; that pre-use check does not make an apprentice the competent person or replace the inspections required by the standard. Structurally defective portable ladders must be identified as defective and withdrawn from service. It also addresses load limits, stable placement and nonconductive side rails where contact with exposed energized equipment could occur. Nonconductive rails do not authorize electrical exposure. The same standard prohibits using a stepladder's top or top step as a step. [1]

This overview is not a climbing, repair or electrical-work procedure. Follow manufacturer instructions and site training.

Worked through

An apprentice is helping prepare equipment for labeling low-voltage cable runs. The nearest stepladder has a cracked side rail. A coworker suggests using it because only two labels remain. The number of labels does not change the observed condition. Report the rail defect, follow the process for identifying and removing the defective ladder from use, and arrange suitable access before work continues.

Paper Exercise

Write a short report for the illustrated ladder: Equipment: identify which ladder. Finding: identify the component and defect. Action: state who was informed and how the defective equipment was kept from being used. Replacement: record what remains to be selected and checked. Model wording: "Orange stepladder, cracked right side rail. Reported to the lead and identified as defective under the site process. Suitable replacement access is still required."

Check Yourself

Where beginners go wrong

Quick Recap

Select for the task. Inspect the actual ladder. Report defects and keep defective equipment out of use.

Sources